Ford Ranger Front Mount Intercooler 3.2L 2011-2022
Ford Ranger Front Mount Intercooler 3.2L 2011-2022
The latest update to the PDI intercoolers for the Ford Ranger makes easier fit with the updated PX3 facelift model through to the last of 3.2L (2022) model. The facelift model also saw a change to the radiator support panel, which allows us to fit the core further back without dropping the height (more than 20mm) and therefore allow the addition of the transmission cooler kit - see below if you have a PX1 as we think it should also fit there with some tweaks.
The new core is 680 x 260 x 76 with slighter tighter end tank setup. This new design works with our class leading PDI transmission cooler kits, which need to be a serious consideration for any owners of the auto transmission model.
For information on our transmission cooler kit CLICK HERE.
Fully cast end tanks ensures they are the strongest possible and least likely to split along a seam. We have had the air temperature sensor cast into the end tank as well as a oil drain.
All piping is stainless steel and the turbo side piping is rerouted to be significantly shorter and with a single 63mm pipe.
Core is positioned further back at the bottom to allow the fitment of a winch.
The first of the PDI Ford Ranger Front Mount Intercooler designs core is 700x300x76mm and has bigger and high flow cast alloy end tanks. These are still available.
If you want to increase the turbo intake size check out our product HERE
If you have a PX1 Ranger with auto transmission, we think it should be possible to fit our updated intercooler and transmission cooler.
The centre (vertical) support is part of the radiator support panel and can not be purchased individually and welded into the original panel. The facelift used a new bonnet latch (attached with 2 bolts) and the centre support design sits slightly further back. After removing the lower bolt we found that the latch was still rock solid so to replicate the design of the PX2 we would cut the lower mount from both the latch and the centre support. The updated intercooler will then be able to sit under the latch and if the intercooler still hits we would consider adding thicker spacers behind the upper intercooler mount or adjusting the centre support in the area just under the latch - call us to discuss.
